Instruction Manual

ManualsBrandsDetex ManualsSafetyAO19-2 Push

With motor / gearbox

perpendicular to enclosure,

insert splined shaft into

shaft hole

Rotate motor / gearbox

to almost horizontal position

being careful not to let switch

assembly hit enclosure

(Note: For clarity, switch wires not shown in views)

Switch Assembly

Rotate motor / gearbox into

enclosure, letting shoulder of

gearbox drop down into shaft

hole. Align screw holes at bottom

& install all 4 screws before

tightening

104852Page5

Operator Installation

EachOperatorislabeledPrimaryorSecondaryandtheunitcaseislabeledoneachend,either

PrimaryorSecondary.

RemoveanOperatorfromtheboxandmatchittotheproperendofthecase.

Withthemotorendawayandslightlybelowtheopenedgeofthecase,inserttheoperatorshaft

throughtheholeinthebottomofthecase.

Carefullyliftandturnthemotorintothecase,beingcarefulnottodamagetheswitchesontopofthe

operator.

SecuretheOperatortothebottomofthecasewiththe1/4-20x13/4”Phillipsatheadscrews

(provided).

Attachthemotorgroundwire(green)tothebackofthecasewherelabeledwiththe10-24x1/4”

Phillipsbuttonheadscrew(provided).

ConnectthewhiteplugoftheOperatorharnessintothecontrol.

Repeatprocessforoppositeside.