Instruction Manual

Installation
Hanger Plate Location for Twin Push Unit
Thehangerplateshouldbelocated5/8”fromtheoutsideedgeofthehingejamb,(typical13/4”
frameface)levelandushwiththebottomoftheheaderofthedoorframe.Barclampthe
hangerplate.Usinghangerplate,markanddrillholesintoheaderframe,solidwallorwallstud.
Fastenusingappropriatetypeandsizescrews(Detexrecommendsusingatheadtype).
Note:Drillingdebrisaccumulatedinhangergroovetrackscanpreventtheoperatorfromseating
uniformlywhenmounting.Removedebriswiththinbrush.Maskingtapecanalsobeusedto
preventdebrisfromcollectingingroove.
Lifttheoperatorandlowerontothewebsofthehangerplatebracket.Besurebothtopandbottom
areengaged.
104852Page4
Oncetheyareseated,pulldownuntilunitiscompletelyushandscrewscanbereplacedintop
corners.
HangerPlate
Replace
Screw
here
Replace
Screw
here