User guide

Installation
104853Page4
SECURE HANGER WITH SCREWS
5/8”
1-1/16”
Oncetheyareseated,pulldownuntilunitiscompletelyushandscrewscanbereplacedintop
corners.
Lifttheoperatorandlowerontothewebsofthehangerplatebracket.Besurebothtopand
bottomareengaged.
Replace
Screw
here
Replace
Screw
here
Hanger Plate Location for Twin Pull Unit
Thehangerplateshouldbelocated5/8"fromtheoutsideedgeofthehingejamb,(typical13/4”
frameface)leveland1-1/16”abovebottomofthedoorframe.Barclampthehangerplate.
Usinghangerplate,markanddrillholesintoheaderframe,solidwallorwallstud.Fastenusing
appropriatetypeandsizescrews(Detexrecommendsusingatheadtype).
Note:Drillingdebrisaccumulatedinhangergroovetrackscanpreventtheoperatorfromseating
uniformlywhenmounting.Removedebriswiththinbrush.Maskingtapecanalsobeusedto
preventdebrisfromcollectingingroove.