User Manual

16-1/2”
104850Page7
Door Foot Location - for Push Units
Thecenterofthedoorfootshouldbelocated161/2"fromthehingesideofthedoorpaneland
shouldbelevelwhentherodisinsertedinthesleeveattachedtothearm.
Markthedoorforthedoorfootholesandsecurethefoottothedoorwiththesuppliedscrews.
Turnthe3-waytoggleswitchtothe“HOLD”position.
Withthedooratfullopen,holdthesteelrodnexttotherodconnectorattheendofthearm,mark
andcuttherodsoitwilltintotherodconnector.Therodlengthshouldallowtherodtobesecured
withbothsetscrewsandallowforadjustmentofthedooropening.Inserttherodintotheconnector
withthedoorinfullopenpositionandadjustuntilthedesiredopeningisachieved.Tightentheset
screwstosecuretherod.
BentArm-
P/N-12731-X
RodConnector-
P/N-12736-X
DoorFoot-
P/N-12735-X
Securewith
screwsprovided
SwingArmRod-
P/N-12734-X
MarkandCut
3/8-24AcornNut-
P/N-12741-X
FemaleRodEnds-
P/N-12738-X