User Manual

104850Page6
Push Arm Installation
ReviewtheInstallationGuideforDetexLowEnergyAutomaticDoorOperatorControlModule,P/N
104827beforeproceeding.Wehavepresetcontrolstoapproximatesettings.
Turnthe3-waytoggleswitch,locatedatendofenclosure,to“HOLD”position.
Theoperatorwillactivateandthemotoroutputshaftwillrotate240°(degrees).Whileinthefull
openposition,attachthearmontotheshaftsothatitispointedata70°-80°(degrees)angle
throughthedooropening.Tightenthescrewonthearmtosecureittotheshaft.
Besurethemotorgearshaftisfullopenpositionbyforcingarmtorotatepastit’sstopposition.
Ifyoucanrotategearshaftbeyondit’sposition,increasethe“BACK-CHECK”andHOLDspeeds.
SwitchtoggletoOFFthenbackto“HOLD”.Realignarminproperposition.Tightenthescrewon
thearmtosecureittotheshaftandapplythesafetywashertothebottomofshaft.
Armplacementinfullopenposition
ARM
Tighten
screw
Tightenscrew
and
safetywasher