Instruction Manual

Detex Corporation, 302 Detex Drive, New Braunfels, Texas 78130 (830)629-2900 /1-800-729-3839 /FAX(830)620-6711

E-MAIL: detex@detex.com INTERNET: www.detex.com

101292 November 19, 2007

INSTALLATION INSTRUCTIONS FOR 02D/02DT/02DU OUTSIDE LEVER TRIM

DETEX INS-101292 PAGE 1

PAGE 1
01292 November 19, 2007 Detex Corporation, 302 Detex Drive, New Braunfels, Texas 78130 (830)629-2900 /1-800-729-3839 /FAX(830)620-6711 E-MAIL: detex@detex.com INTERNET: www.detex.
PAGE 2
02 Outside Lever Trim Tools Required Power Drill Pencil Hammer Safety Glasses Tape Measure Screw Driver Center Punch Switching Handing from RHR to LHR Place trim on a clean surface with this view facing up. Use 1/8” Allen Wrench to remove screw. Pull Back Blocking Plate. Caution: do not lose the brass shear pin located inside assembly. Turn Handle and plate 180 deg. Replace plate, add permanent thread locking adhesive and tighten Allen Screw.
PAGE 3
Door Preparation 1 2 Punch Marked Holes Mark Backplate (wide stile shown) FLOOR Note: All Holes Must Be Drilled Straight and Level Interior Door Face Drill 1/2" Outside Holes. 3 4 Drill 5/16" Holes Thru Door (Make sure the Drill is Straigt & Level) 5 1/4-20x1" screws provided in Exit Device Hardware Kit PlaceTrim Unit to Exterior Door Face.