Owner`s manual

SETUP AND CALIBRATION, CONT.

UNLOAD WEIGHT

With the display showing uLduLd, remove the 2 lb test weight from the scale tray. Allow

approximately five seconds for the scale to stabilize, then press the ON/TARE key to continue

the calibration. Dashes will be displayed from the left to the right of the display momentarily,

then the display will change to untunt.

If ErAErA is displayed during the LOdLOd or ulduld calibration sequence, remove the test weight

from the scale and verify that it is the correct weight (2 lbs) or insure that the scale is

empty and nothing is touching the scale tray. The display will return to LOdLOd or ulduld

allowing you to continue with calibration and setup.

WEIGHING UNITS

With the display showing untunt, press the WT/UNIT key to display the current setting for the

default weighing unit. The display will show ------ and turn on the red indicator for the weight

unit (oz or gm) or 11 and the red indicator for (gm) for the "Grams only" mode. Press the

WT/UNIT key until the desired weight unit is indicated. Press the ON/TARE key to save the

setting.

AUTOMATIC SHUTOFF

The display will show ASHASH. Press the WT/UNIT key to display the current setting. Press the

WT/UNIT key until the desired number of minutes of inactivity before the scale will

automatically shutoff is displayed. Values of 1, 2, 5, 10, or 15 minutes or OFF are available.

Selecting OFF will disable the automatic shutoff feature. Press the ON / TARE key to save the

setting.

POWER UP ZERO

The display will show PuOPuO. Press the WT/UNIT key to display the current setting. Press the

WT/UNIT key to select YESYES to enable or no no to disable. Press the ON / TARE key to save the

setting.

DONE

The scale will briefly display dnEdnE, then reset to the Operation weight mode.

SETUP REVIEW

The Setup Review mode allows you to review and change several operational parameters as

desired without having to enter the setup and calibration mode. To enter the setup review mode,

you need to turn the scale off by pressing the WT/UNIT and ON-TARE keys simultaneously and

then pressing and holding the ON-TARE key until the red indicator of the selected weight units

begins to flash. After the red indicator begins to flash, release the ON-TARE key. The display will

show untunt, the prompt for the weighing units. Refer to the instructions listed in the Setup and

Calibration section for information on how to change these parameters. The parameters in the

setup review that can be change are as follows:

WEIGHING UNITS AUTOMATIC SHUTOFF

Location of

Calibration

Switch