Owner`s manual

1
Push here
and pull up
INSTALLATION
UNPACKING
Before beginning installation of your scale, make certain the instrument has been received in
good condition. When removing the scale from its packing, inspect it for signs of damage, such
as exterior dents and scratches. Keep the carton and packing material for return shipment if it
should become necessary. It is the responsibility of the purchaser to file all claims for any
damages or loss incurred during transit.
1. Remove the scale from the shipping carton and inspect it for any signs of damage.
2. Plug-in the 9 VDC adapter or install the battery. Refer to the POWER SUPPLY or
BATTERY sections of this manual for more instruction.
3. Place the scale on a flat level surface, such as a table or bench.
4. The scale is now ready for use.
POWER SUPPLY
To apply power to the scale using the supplied 9 VDC, 100 mA power supply, insert the plug from
the power supply cable into the power jack on the back of the scale and then plug power supply
into the proper electrical outlet. The scale is now ready for operation.
DO NOT connect the plug-in power supply to
the scale with a battery installed in the scale.
BATTERY
The scale can use a "9V" size Alkaline battery (not included). If you wish to operate the scale
from a battery, you must first obtain and install the battery. The battery is contained in a cavity
inside the scale. Access is via a removable cover on the bottom of the scale.
INSTALLING THE BATTERY
1. Turn the scale over so that the display is facing down and place it upside down on a flat
level surface, such as a table or bench.
2. Locate the battery cover on the bottom of the scale.
3. Remove the cover by pushing in on the tab and pulling up exposing the battery connector.
4. Connect the snap connector to a 9 volt battery and place the battery in the cavity.
5. Replace the battery cover (it will click when locked in place) and return the scale to the
upright position.
6. Check the scale for proper operation.