Owner`s manual

8528-M303-O1 PS-7
Page 4
CONFIGURATION
Your scale has been pre-configured at the factory and should not require configuration for use in
most applications. In the event that the factory settings do not meet the requirements of your
application, the following describes the steps to configure the scale.
TO BEGIN CONFIGURATION:
1. Press the ON/OFF key to turn on the scale.
2. Press and hold the ZERO key for 3 seconds. When the display shows +5< , release the
ZERO key to enter the Configuration mode. The display will change to show (1.< .
WEIGHING UNITS
To select “lb/OZ” (pounds/ounce) weighing units:
1. With the display showing (1.< , press the ZERO key. The display will change to show
both “lb” and “OZ”.
2. Press ZERO key to display lb/OZ status.
3. Press the UNIT key to toggle between:
Enable (display will change to $1 ) or
Disable (display will change to $ ).
4. Press the ZERO key and then the UNIT key 5 times. The display will change to (1.< .
5. Proceed to AUTOMATIC SHUTOFF.
To select “OZ” (ounce only) weighing units
1. With the display showing (1.< , press the ZERO key and then the UNIT key. The
display will change to show “OZ”.
2. Press the ZERO key to display OZ status.
3. Press the UNIT key to toggle between:
Enable (display will change to $1 ) or
Disable (display will change to $ ).
4. Press the ZERO key and then the UNIT key 4 times. The display will change to (1.< .
5. Proceed to AUTOMATIC SHUTOFF.
To select “1/8 OZ” (fractional ounce) weighing units:
1. With the display showing (1.< , press the ZERO key and then the UNIT key 2 times.
The display will change to show “OZ” and “1/8”.
2. Press ZERO key to display 1/8 OZ status.
3. Press the UNIT key to toggle between:
Enable (display will change to $1 ) or
Disable (display will change to $ ).
4. Press the ZERO key and then the UNIT key 3 times. The display will change to (1.< .
5. Proceed to AUTOMATIC SHUTOFF.