Owner`s manual

8528-M303-O1 PS-7
Page 6
GRAVITY COMPENSATION
The Gravity Compensation for your scale has been pre-configured at the factory and should not
require changing in most locations. In the event that the factory settings do not meet the
requirements of your location, contact the factory for the value for your location.
With :=a enable from the function setting of the Configuration mode, the scale will use
the factory set value of 9.797 for the Gravity Compensation.
If the :=a is disabled, the scale will use the value obtained from the factory and entered
by the operator for the Gravity Compensation.
Changing the Gravity Compensation value:
1. Press the ON/OFF key to turn on the scale.
2. Press and hold the UNITS key 3 seconds to enter Gravity Compensation mode, the
display will show 9.797 (or the current value).
3. Enter the desired gravity value (press the ZERO key to choose number from 0~9, and
press UNITS key to move to right digit.
4. Press ON/OFF key (to confirm the entered gravity) and return the scale to the normal
operating mode.