Product Manual

AWS (Automatic Web Server activation): This setting sets how the configuration web page

will be presented. By default, when viewing this web page, this setting will reset to zero. It is

very important to enter the correct setting in order to enable this configuration web page if

settings need to be changed. Following are valid settings for this parameter and their

descriptions.

1 = Web server will automatically start on next power cycle. This setting will expose

ALL of the MedVue WiFi option card parameters and is not recommended for normal

use.

100 = HTTPS secure web server will be started automatically (same as ‘1’ but using

secure web connection).

200 = HTTPS secure web server will be started automatically (same as ‘201’ below but

using secure web connection).

201 = (RECOMMENDED) HTTP web server will start automatically and will show the

web pages described in this addendum. This is the recommended setting for this

parameter.

LATI (TCP Listening Socket to service remote AT+i commands): This starts a listening

port for remote AT+i commands. This is not recommended for normal operation and should be

set to ‘0’ to disable this functionality.

Once all settings have been entered, click “Submit” at the bottom of the webpage in order to

save the parameters.

It may be necessary after changing parameters to power cycle the weight analyzer for the

settings to take effect.

NOTE: It is important to wait at least 20 seconds before attempting the power cycle

to ensure all settings have been set in the weight analyzer option card.

8555-M519-O1  MedVue MVWIFI Operation