Owner's manual

9200-0305-0M Rev B  LSM Series

TRANSPORT MODE SETUP

Use the following instructions to convert the scale from Weigh mode to Transport mode.

1. Turn off the power switch located in the weigh center. Close and latch the weigh center cover.

2. On each corner of the scale, using both hands, securely grip the cam handle and rotate it

away from the center of the scale to lower the platform and disengage the scale.

NOTE: The Cam levers point OUT away from the center of scale (and each other) in the

Transport mode and IN towards the center of scale (and each other) in the Weigh mode.

Refer to the decals on each load cell tower cover for direction of levers in each mode.

WARNING! The lift mechanism is an over center cam style lift and lock. Always

grip lift handle with two hands securely when raising and lowering the scale.

3. Swing both tongue arms together and insert the safety pin.

4. Ensure the dump valve located on the battery box is closed.

5. Turn on the air pump to add air to the scale suspension to raise the scale frame off the

ground. If shims were used, they should be removed at this time.

6. Close all air valves located directly above the air bags.

NOTE: During scale towing, all valves MUST be closed.

7. On each axle, install the suspension stops and secure with the retaining clips.

8. Extend the jack to raise the scale hitch off the ground and approximately high enough to clear

the truck hitch.

9. Install the retaining clip in the tongue arms safety pin to secure it.

10. Position the truck near the scale hitch.

11. Retract the jack to lower the scale hitch onto the truck.

12. Connect the scale hitch to the truck and connect all wiring between scale and truck.

13. Connect the safety chains.

14. If not performed in step 11, completely retract the jack.

WARNING! Do not move vehicle until scale is in transport mode, all air valves are

closed, jack is retracted, suspension stops are installed and safety chains are

attached.