Owner's manual
9200-0305-0M Rev B LSM Series
17
MWC225P Indicator Operations
Power the Scale
Press the power switch to turn the indicator ON.
Enter the Shrink Value
The shrink value is the percentage removed from the total gross weight as shrinkage. It is
limited to a range from 0.00 to 100.00 percent.
Press the SHRINK key at any time to view and/or modify the shrink percentage.
Enter the Number of Animals
1. Insert a ticket into the printer. Press FORWARD on the printer to secure the ticket.
2. Verify the scale is level and within tolerance. If scale is tilted out of tolerance the indicator will
display dashes and NO WEIGHT along with the out-of-tolerance angle measurements
(Pitch and Roll) as a percentage.
3. Press ZERO key to re-zero scale if needed.
4. Load animals onto scale.
5. Press WEIGH key.
6. The indicator will prompt ENTER HEAD COUNT. Using keypad, enter the number of
animals and press ENTER key. The head count, current count along with the Gross weight
and Average weight per head will be displayed and a ticket will begin to print and advance.
Each time WEIGH key is pressed, the weighment will display the head count in the center
column (as Current count), along with the Gross weight and Avg (average) weight per head.
The left column is the previous weighment. The right column is the running total.
7. Unload animals from scale.
8. Follow steps 4 through 7 until all animals from the current batch have been weighed.
9. Press FINISH key to complete current batch of animals.
The shrinkage percentage will be applied and the transaction totals will be printed (before
they are reset). Pressing this key terminates the transaction, resets all the counts to zero and
increments the transaction number.
10. Press REPRINT key at any time prior to starting the next batch to reprint the last ticket.
NOTE:
The transaction number can be modified (before a transaction) by pressing the TIME/DATE
key. Press the ENTER key twice to skip the Time and Date prompts and then the 225 will
prompt Trans Num: XXXXX. Using the numeric keys, enter the new transaction number
and then press the ENTER key.