Owner's manual

9200-0305-0M Rev B  LSM Series

INSTALLING GATHERING PANELS

1. On the corner of the scale frame, locate the

opening for the gathering panel.

2. Insert the tube from the gathering panel into

the frame opening.

3. Position the gathering panel at the desired

angle away from the scale.

Note that the gate will only open slightly past 90 degrees from the cage. Position the gathering

panel on the gate side so that it is close but not touching the gate to avoid a gap large enough for

livestock to get trapped between the gathering panel and the gate.

IMPORTANT! When installing the gathering panels, make sure the gathering panels DO NOT

touch the scale cage. Touching the scale cage will cause inaccurate weigh readings.