Owner's manual

9200-0305-0M Rev B  LSM Series

WEIGH MODE SETUP

Use the following instructions to convert the scale from Transport mode to Weigh mode.

1. Park the scale on a level location as possible. Ensure there are no obstructions or debris

under the scale that would affect weighing accuracy.

NOTE: The scale will weigh properly on up to a 5% tilt angle.

2. On each axle, remove the retaining clip securing the safety pin on the shock suspension stops

and store the retaining clip in the end of the pin as shown.

3. With the drop leg retracted, extend the jack until it lifts the scale hitch from the truck hitch.

4. Disconnect the scale hitch from the truck hitch and unplug all wiring. Move the truck clear of

the scale.

5. Remove the retaining clip securing the safety pin holding the tongue arms together and store

the retaining clip as shown.