User manual

11.5.1 INSTALLATION
With power disconnected locate archway and console in their desired locations;
Locate connecting wire and protect from tampering or vandalism, as necessary;
Plug the wire into the rear of the console;
Open the Access Door of the detection unit;
Remove three (3) screws that hold the controller cover;
• Plug the wire into the Circuit Board connector as shown on Page 23;
Replace covers and connect to power.
11.6 BATTERY BACK-UP MODULE (OPTIONAL)
This optional module is a field-installable assembly that provides power to operate the
Magnascanner CS 5000 for up to twenty (20) hours on a fully charged battery. System software
includes an alarm feature that alerts the operator to a low-battery condition. This ensures that the
unit continues to operate at its peak performance level.
A switch is provided on the side of the battery module to fully disconnect battery power. This
switch whould be set to its OFF position anytime the system is being stored and anytime the sys-
tem is not in use and is not connected to AC power for more than 24 hours. Standby circuitry will
discharge a fully charged set of batteries in about ten (10) to fifteen (15) days whenever the switch
is not turned off.
11.6.1 INSTALLATION
1. Open the access door of the detection unit;
2. Disconnect the AC power plug from the Power Supply Module;
3. Remove the three (3) screws that hold the Controller Module Cover;
4. Remove the four (4) acorn nuts that are attached to the Battery Pack Module mounting studs;
5. Install the Battery Pack Module and replace the acorn nuts;
6. Disconnect the Power Supply Module connector on the upper left of the Controller Circuit
Board;
CS 5000
User Manual
©2005 GARRETT METAL DETECTORS 43 PN 1530100 REV E