User manual

11.4.2.1 Case I: Use internal power

• Disconnect from AC power;

• Open Access Door of detection unit;

• Remove three (3) screws that hold

controller cover;

• Connect the relay or device to control, as

shown at right;

• Replace cover and reconnect power.

11.4.2.2 Case II: Use external power

• Disconnect from AC power;

• Remove three (3) screws that hold

controller cover;

• Connect the relay or device to control,

• Replace cover and reconnect power.

11.4.2.3 Case III: External logic control

• Disconnect from AC power;

• Open Access Door of detection unit;

• Remove three (3) screws that hold

controller cover;

• Connect the relay or device to control, as

shown at right.

• Replace cover and reconnect power.

11.5 REMOTE CONTROL (OPTIONAL)

A complete remote console with all control functions

that are available on the overhead panel is available

for monitoring and controlling functions of the

Magnascanner CS 5000 from a location apart from

the archway.

This remote console is connected to the overhead

unit with telephone-type cable and RJ 45 connectors

which can be easily concealed behind overhead

panels or in 1/2-inch conduit. The remote control

receives its power from the main detector unit.

Pressing a touchpad on the remote console

achieves the same result as pressing the same

touchpad on the overhead panel, except for the

VOLUME and TONE adjustment.

Regulating alarm volume and tone must be done

separately at the remote console and at each unit it

controls. This enables the audio to be set separately

at the required levels for the console and archway.

A 50-foot cable is standard, but custom lengths are

available.

CS 5000

User Manual