User manual

10.8.3 COUNTER

Since the current traffic count of the CS 5000 is usually displayed, this touchpad will be needed only

for resetting the counter. Pressing and holding this touchpad for ten (10) seconds causes the count-

er to return to zero (0). Whenever the LCD displays information other than the current traffic count,

pressing this touchpad will cause the count to appear.

10.8.4 VOLUME

When this touchpad is pressed, the volume level of the unit’s audible alarm will be

displayed on the LCD display. By using the + and - touchpads, operators can raise or lower the vol-

ume.

10.8.5 + AND -

These touchpads will be used to increase or decrease various numerical settings and for certain

On/Off functions.

10.8.6 PROGRAM

When this touchpad is pressed, the settings for Program and Sensitivity will appear on the LCD dis-

play.

All of the preceding touchpad functions will be available to operators of the detector at all times. The

ACCESS touchpad will be used only by supervisors.

10.9 ACCESS TOUCHPAD

This touchpad will be used only by supervisory management personnel. It permits changing the

Program and Sensitivity codes and also is used to control such functions as synchronization of mul-

tiple units, pulse frequency and tone. The unit further protects security of control settings by main-

taining a non-resettable sequence code that indicates any attempt at seeking access to the settings.

A Tamper Alarm sounds within 10 seconds after the ACCESS touchpad is pressed unless a prop-

er access code is entered. Follow supervisors’ instructions concerning response to this Tamper

Alarm.

10.10 OPERATORS’ RESPONSIBILITIES

• The primary responsibility of any operator is to follow all instructions of supervisors.

• These directives will govern the response of operators to alarms and other situations that will be

encountered. The basic continuing responsibility of the operator will be to ensure that the CS 5000

operates properly at all times as indicated by its LCD panel and that ALL alarms are investigated.

• Remember that the cause of every alarm MUST be determined.

10.11 OPERATORS’ INSTRUCTIONS

All personnel who are associated with the detector should watch a video presentation on the

Magnascanner CS 5000 in addition to studying this User Manual. Carefully following the instructions

in the Manual will help ensure the security of any facility this walk-through detector is expected to

protect.

As described in the CONTROLS section of this manual, CS 5000 controls are located in the top sec-

tion of the archway. If the green READY light is not visible on the control panel, press the OPER-

ATE touchpad. Operators can also adjust volume of the alarm and can reset the traffic counter.

CS 5000

User Manual