User manual

8. TECHNICAL SPECIFICATIONS

8.1 ELECTRONICS

Digital-controlled pulse induction metal detector with microprocessors utilized in both detection and

control circuitry. Designed for tailoring specific programs to fulfill various security applications.

Electronics are modular and designed for easy plug-in and change-out.

8.2 MEMORY

All program selections and settings are maintained in electrically erasable non-volatile memory. The

unit will maintain all settings even when disconnected from power. No battery is required for memo-

ry retention.

8.3 OVERHEAD CONTROL UNIT

LCD Display, LED bar graph and control touchpads plus all wiring, connections and electronics are

integrated in a single overhead compartment that eliminates exposed wires and an external control

box.

8.4 CONTROL OUTPUTS

Low-voltage solid state switches. AC switch can control 48V at 100mA; normally open switch is iso-

lated from system ground. DC switch can sink 100mA from a 15V source. Connections to 15V and

system ground are provided for use with internal or external power source.

8.5 CONNECTORS

AC switches, DC switches and synchronization are connected through a screw terminal block.

Remote indicators and remote console are connected through RJ-45 telephone- type connections.

8.6 INDICATORS

READY light indicates unit is operational; ALARM light and audible alarm are activated when target

amount of metal is detected; LED Bar Graph indicates amplitude of alarm signal.

8.7 TRAFFIC COUNTER

Built-in and resettable with current reading easily available on LCD panel.

8.8 TAMPERPROOF

Dual access codes required to set or change the operation of the unit: one level for use by superv-

iors in selecting programs and sensitivity; the other for initial set-up and overall control. Security of

the unit’s calibration settings is further protected by a non-resettable sequence code that allows

supervisors to maintain a precise log of all changes ever made to the program, sensitivity or set-up,

as well as any attempts at changing them. An audible alarm reports any unauthorized attempt at

access.

8.9 CONSTRUCTION

Attractive scratch- and mar-resistant laminate with resilient end caps; control panel and crosspieces

of heavy duty aluminum.

8.10 REGULATORY STANDARDS

Meets (or exceeds) all 1991 Federal Aviation Administration airport applications specifications as

well as all requirements of National Institute of Law Enforcement and Criminal Justice (NILECJ) stan-

dard 0601.00, security levels 1-5.

CS 5000

User Manual