User manual

6. SUPERVISOR ADJUSTMENTS

Several adjustments may be made at the Supervisor’s Level (Access Code #1). These are primari-

ly program/sensitivity settings and the operation of the IR Sensor. These supervisor’s adjustments

can be accessed only through use of a four-digit code (See instructions for altering Access Code #1

under Installation Adjustments, Section 5.7)

To access the Supervisor Adjustment Mode for the first time, press the ACCESS touchpad and the

factory preset code of 1234. The factory default settings of PROG D SENS 160 will be displayed

on the LCD with the program designation blinking. Pressing the ACCESS touchpad will permit scroll-

ing through these selections.

Special Note

For maximum security it is recommended that both Access Code numbers be changed from the fac-

tory default settings and that the numbers be known only to those who use them. Record the new

code numbers on the Access Settings card that accompanied this User’s Manual. It is also suggest-

ed that codes be changed periodically, especially when any changes are made in personnel with

access to the codes.

6.1 PROGRAM

The programs detailed in Section 11 have been developed for use by the Garrett

CS 5000. These brief descriptions will give some indication of the intent of each program, but a final

judgment on the setting of each individual unit should be determined by the intent of its installation.

After the Program number is accessed through use of the four-digit code, + touchpad can be used

to increase the number, and the - touchpad to lower it. Press ACCESS for next adjustment or OPER-

ATE to return to normal operation.

6.2 SENSITIVITY

This option permits the unit to be adjusted (range of 1 to 200) to the proper level of

sensitivity within a chosen program. Press ACCESS until the SENS and the number are displayed

on the LCD. Use the + and - touchpads to adjust the number. Sensitivity of detection will be

increased as the number is made larger, allowing alarm responses on smaller targets.

After the desired Sensitivity number has been selected, press ACCESS for next adjustment or

OPERATE to return to normal operation.

6.3 IR ANALYSIS

The Garrett CS 5000 utilizes an Infrared Sensor to enhance the operation of the unit in special sit-

uations. IR Analysis — ON or OFF appears on the LCD to indicate whether or not the IR Analysis

is being used. The + or - touchpad is used to turn the IR Analysis off and on. Whenever this is done,

it is necessary to press ACCESS for the next adjustment or OPERATE to return to normal opera-

tion.

Utilization of the Infrared Sensor is not required for operation of the CS 5000 and may be disabled

if desired.

Several benefits of the sensor are:

1. The units can operate more effectively by correlating signal responses with actual physical

movement. Because this sensor enables the Magnascanner to detect just those individuals and

objects while they are passing through the detector, it can minimize effects of noise and other

influences.

CS 5000

User Manual