User manual

3.2.2 Install the Power Cord completely through one of the channels at the top of either of the Panels

as shown below. A channel can be found in each of the four corners. Select the corner that will

be convenient in relation to site selection. For overhead power connection, do not insert the

cable through a channel but leave it free at the top.

If using cord set, it must be routed through the channel closest to the Power Module. Care

should be taken to prevent accidental disconnections and exposure to water.

3.2.3 Place the styrofoam packing material on floor as shown and lay the Detection Unit on it with the

touch pad panel facing down. Use four (4) of the Screws and Finishing Washers to connect the

Detection Unit to Panels A and B. Do not tighten.

3.2.4 Open door of the Detection Unit and, first, connect Power Cord. Then, connect Cable A and

Cable B to the Panels as shown.

CS 5000

User Manual