Instruction manual

FINAL ASSEMBLY
Step 1
Place the speaker into the front case as shown in Figure 16. Use two #4 x 1/4” screws and two #4
washers to secure it into place.
Step 2
Push the switch key onto the switch as shown in Figure 17. Make sure that the key-switch is sitting
properly on the switch.
Step 3
Place the PC board into the front case as shown in Figure 18. Attach the back case to the front case
with two #4 x 5/8” screws. Note: There is a small groove that the key switch fits into.
-11-
#4 x 1/4” Screws
#4 Washers
Screws
Switch Key
Figure 16
Figure 17
Figure 18