Owner`s manual

8525-M178-O1 459-CH and 8432-CH
Page 11
8432-CHKGEU SETUP INSTRUCTIONS, Cont.
Battery Installation/Replacement
To install or remove batteries, perform the following steps:
1. Push latch release down flush
with back of indicator and hold
while removing indicator from
bracket on scale.
2. Turn indicator so display is
facing away from you (resting
on keypad).
3. Locate rectangular panel on
back of indicator and remove
thumb screw.
4. To install or replace batteries,
remove panel (lift straight up
and slide out) exposing battery
holder.
5. If installing new batteries,
proceed to step 6. If replacing the batteries, remove all 6 batteries from the battery
holder and then proceed to step 6.
6. Install 6 new “C” size batteries in the battery holder, noting polarity markings located in
battery holder.
7. After placing all 6 batteries in battery holder, replace panel on back of indicator (slide
tab into slot on rear panel) and install thumb screw.
8. Make sure power supply is unplugged, and then turn indicator over
(display facing up) and press ON/OFF key.
9. If display turns on, the batteries have been installed correctly. If not,
remove panel and check for one or more improperly positioned batteries.
10. Return indicator to scale bracket by pushing latch release down flush with back of
indicator and holding. Next, place large end of slotted holes in bracket over screw
heads on back of indicator. Pull down to secure indicator. Release latch release to lock
indicator to bracket.
11. Scale is now ready for operation.
ON/OFF key
Thumb
Screw
12 VDC
Battery Door
+
Latch Release
+