Owner`s manual

8525-M178-O1 459-CH and 8432-CH
Page 8
8432-CH SETUP INSTRUCTIONS, Cont.
Battery Installation/Replacement
To install or remove batteries, perform the following steps:
1. Pull Spring Plunger Release and hold
while removing indicator from bracket
on scale.
2. Turn indicator so display is facing
away from you (resting on keypad).
3. Locate the rectangular panel on back
of indicator.
4. To install or replace batteries, first
remove battery holder cover by
pushing in on the tab and lifting it up.
5. If installing new batteries, proceed to
step 6. If replacing the batteries,
remove all 6 batteries from the battery
holder and then proceed to step 6.
6. Install 6 new “AA” size batteries in the
battery holder, noting polarity markings
located in battery holder.
7. After placing all 6 batteries in battery
holder, replace battery cover.
8. Make sure power supply is unplugged,
and then turn indicator over (display
facing up) and press ON/OFF key.
9. If display turns on, batteries have been
installed correctly. If not, remove
panel and check for one or more
improperly positioned batteries.
10. Return indicator to scale bracket by
placing screw heads on back of
indicator into large end of slotted holes
in bracket. Pull down to secure the
indicator. Spring plunger will lock
indicator to bracket.
11. Scale is now ready for operation.
Push in and
lift here
Battery
Cover
+ -
+ -
+ -
- +
- +
Power Supply
Connector
- +
Spring
Plunger
Release