Waist-High Stand-On Scale Models 6855, 6855KGEU 6856 & 6856KGEU Operating Instructions 1930-M458-O1 Rev C 04/09 CARDINAL SCALE MFG. CO. PO BOX 151 x WEBB CITY, MO 64870 PH (417) 673-4631 x FAX (417) 673-5001 Web Site - http://www.detectoscale.com Technical Support: Ph: 866-254-8261 y techsupport@cardet.
WAIST-HIGH STAND-ON SCALE Thank you for purchasing our model 6855 (6855KGEU) or 6856 (6856KGEU) Waist-High Stand-On Scale. It has been manufactured with quality and reliability at our factory in Webb City, MO USA. Your scale has been tested before leaving our factory to insure accuracy and dependability for years to come. This manual is provided to guide you through the operation of your scale. Please read it thoroughly before attempting to operate your scale and keep it handy for future reference.
This page intentionally left blank.
UNPACKING INSTRUCTIONS x Remove staples or cut along bottom of carton. Lift carton off pallet. x Check for any damage incurred in shipping. If scale has been damaged, place a claim with the carrier. It is the responsibility of the purchaser to file all claims for any damages or loss incurred during transit. Use the original carton and shipping material to return the scale. x Cut packing straps securing scale to pallet.
INDICATOR INSTALLATION To install the indicator on the scale column bracket, place the screw heads on the back of the indicator into the large end of the slotted holes in the bracket. Pull down to secure the indicator. The spring plunger will lock the indicator to the bracket. See Figures No. 1, 2 and 3. Spring Plunger Figure No. 2 Figure No. 1 Power Supply Scale Cable Spring Plunger Release Figure No.
INDICATOR INSTALLATION, CONT. Battery Installation/Replacement To install or remove the batteries, the following steps should be followed: 1. Remove indicator from scale or desk stand/wall mount bracket if used. 2. Turn the indicator so that the display is facing away from you. Push in and lift here Battery Cover 3. Locate the rectangular panel on back of indicator. 4. To install or replace the batteries, first remove the battery holder cover by pushing in on the tab and lifting it up. Refer to Figure No.
OPERATION DO NOT operate the keypad with pointed objects (pencils, pens, etc). Damage to keypad resulting from this practice is NOT covered under warranty. To Weigh 1. Set scale on any hard, level, flat surface or low-cut carpet. 2. Press ON / OFF key to turn on indicator. 3. Press ZERO key to zero weight display. The ZERO and lb or kg annunciator will turn on to show that scale is ready for use. 4. Place patient on scale and read weight display. 5. Remove patient from scale. Zero Weight Display 1.
HEIGHT ROD INSTRUCTIONS Height Rod Hole Location x Please check Height Rod hole locations before installing Height Rod. x Some models may require holes to be drilled. x Please follow the measurements for drilling holes if necessary. x After holes have been drilled, please follow installation instructions. x Install the two (2) #10 x ½” hex head screws from the hardware pack into the column. 28 13/16 IMPORTANT! Measure from top of scale base. #29 (.
PART IDENTIFICATION Indicator Alternate Mounting Configuration 1930-M458-O1 y Waist-High 685X Series Page 8
PART IDENTIFICATION, CONT.
PART IDENTIFICATION, CONT.
PART IDENTIFICATION, CONT. ITEM QTY QTY NO.
STATEMENT OF LIMITED WARRANTY Detecto Scale warrants its equipment to be free from defects in material and workmanship as follows: Detecto warrants to the original purchaser only that it will repair or replace any part of equipment which is defective in material or workmanship for a period of one (1) year from date of shipment. Detecto shall be the sole judge of what constitutes a defect.
STATEMENT OF LIMITED WARRANTY Conditions Which Void Limited Warranty This warranty shall not apply to equipment which: A.) Has been tampered with, defaced, mishandled or have had repairs and modifications not authorized by Detecto. B.) Has had serial number altered, defaced, or removed. C.) Has not been grounded according to Detecto’s recommended procedure. Freight Carrier Damage Claims for equipment damaged in transit must be referred to the freight carrier in accordance with freight carrier regulations.
1930-M458-O1 y Waist-High 685X Series Page 14
