ELECTRONIC PHYSICIAN Waist-High Scale 6027 and 6029 Series Owner’s Manual 0044-M078-O1 Rev G 11/06 CARDINAL SCALE MFG. CO. PO BOX 151 v WEBB CITY, MO 64870 PH (417) 673-4631 v FAX (417) 673-5001 Web Site - www.detectoscale.com Technical Support: Ph: 866-254-8261 v techsupport@cardet.
INTRODUCTION Thank you for your purchase of our Detecto Electronic Physician Waist-High Scale. It was built with Detecto quality and reliability at our factory in Webb City, Missouri. This manual will guide you through installation, and operation of your scale. Please read it thoroughly before attempting to operate this scale and keep it handy for future reference.
UNPACKING INSTRUCTIONS v Remove scale from carton by lifting up with equal force from column and platform base of the scale. v Inspect the scale for any signs of damage due to shipping, such as exterior dents and scratches. It is the responsibility of the Purchaser to file all claims for any damages or loss in transit incurred. Retain packing and shipping carton for return of scale if necessary. v Remove all plastic wrapping, foam ¿llers and cardboard material from the scale.
INSTALLATION, Cont. Batteries Battery operation is a standard feature of the weight indicator, although the batteries are optional (not included). The indicator can be operated from 6 "AA" size Alkaline, Ni-Cad or NiMH batteries. You must first obtain and install batteries before operations can begin. Batteries are contained in a battery holder inside the indicator. Access is via a removable panel on the back of the indicator. When using batteries, all 6 batteries must be of the same type.
INSTALLATION, Cont. Battery Installation/Replacement To install or remove the batteries, the following steps should be followed: 1. Remove indicator from desk stand/wall mount bracket if used. 2. Turn the indicator so that the display is facing away from you. Push in and lift here Battery Cover 3. Locate the rectangular panel on back of indicator. 4. To install or replace the batteries, first remove the battery holder cover by pushing in on the tab and lifting it up. Refer to Figure No. 2. 5.
OPERATION DO NOT operate the keypad with pointed objects (pencils, pens, etc). Damage to keypad resulting from this practice is NOT covered under warranty. Basic Weighing Operation To Weigh 1. Set scale on any hard, level, flat surface or low-cut carpet. 2. Press ON / OFF key to turn on indicator. 3. Press ZERO key to zero weight display. The ZERO and lb or kg annunciator will turn on to show that scale is ready for use. 4. Place patient on scale and read weight display. 5. Remove patient from scale.
ERROR AND STATUS DISPLAYS Display A ::A A$ A Meaning General error, invalid keypad entry was attempted. Attempting to display a negative number greater than –9,999 or a positive number greater than 99,999 A<:"A Indicates an attempt to zero a weight outside scale zero range. (See Four Percent Zero Tracking Range Limit). A(1+A Motion is present when indicator is attempting to perform one of the following operations: Power Up Zero or Zero Weight Display ".3 Indicates calibration is necessary.
HEIGHT ROD INSTRUCTIONS, Cont. Height Rod Installation 1. Remove Height Rod from shipping container. Inspect for signs of damage. Contact Detecto Customer Service Department if necessary. Column Height Rod Bracket 2. Remove cardboard insert from height rod. 3. If not already installed, insert the four hex head screws from the hardware pack into the holes in the back of the column and tighten them with the included wrench until the hex heads are 1/8" from the column. Pre-Installed Screws 4.
STATEMENT OF LIMITED WARRANTY Detecto Scale warrants its equipment to be free from defects in material and workmanship as follows: Detecto warrants to the original purchaser only that it will repair or replace any part of equipment which is defective in material or workmanship for a period of one (1) year from date of shipment. Detecto shall be the sole judge of what constitutes a defect.
STATEMENT OF LIMITED WARRANTY Conditions Which Void Limited Warranty This warranty shall not apply to equipment which: A.) Has been tampered with, defaced, mishandled or have had repairs and modifications not authorized by Detecto. B.) Has had serial number altered, defaced, or removed. C.) Has not been grounded according to Detecto’s recommended procedure. Freight Carrier Damage Claims for equipment damaged in transit must be referred to the freight carrier in accordance with freight carrier regulations.
0044-M078-O1 v 6027 and 6029 Page 10
