Specifications

8200-M411-O1 Rev D y 210/215 Installation & Technical 31
SETUP AND CALIBRATION, CONT.
Single-Point for Zero Only (Only Zero) Calibration
!> – First Calibration Weight
The display will show !>. This is the first of two calibration steps.
• Insure the scale is empty.
• Press the ENTER key.
• Starting at the left and proceeding right, a series of dashes will appear on the display.
The dashes will stay on the display momentarily, then disappear, after which the
display will show: !>.
!> - Second Calibration Weight
The display will show !>. This is the second of two calibration steps.
• Press the ZERO key.
• The display will advance to *-6.
Calibration “” Numbers
1. With !> displayed, press the "diamond T” TARE key.
2. At the > prompt, press the ENTER key to show the current value of the  number.
3. If the > number displayed is acceptable, press the ENTER key again to save it.
4. Otherwise, use the numeric keys to enter a new > number, then press the ENTER key.
5. Repeat steps 2 through 4 for >, > and >.
NOTE! If any components have been changed that affect calibration and/or
your scale is used in a commercial application and must be "Legal for Trade"
you cannot use the “C” numbers to re-calibrate.