Specifications

8200-M411-O1 Rev D y 210/215 Installation & Technical 30
SETUP AND CALIBRATION, CONT.
Dual-Point without Zero (False Zero) Calibration
!> – First Calibration Weight
The display will show !>. This is the first of two calibration steps. This weight is
the TEST WEIGHTS / TEST LOAD.
• Place the weights on the scale platform.
• Using the numeric keys, input the value of the calibrated test weights / test load, then
press the ENTER key. NOTE! When entering values for !>, the digits start
displaying on the right side of the display and proceed to the left. When large values
are used (more than 3 digits), the !> prompt will automatically scroll off the left
side of the display to show the additional digits on the right as they are entered.
• Starting at the left and proceeding right, a series of dashes will appear on the display.
The dashes will stay on the display momentarily, then disappear, after which the
display will show: !>.
!> - Second Calibration Weight
The display will show !>. This is the second of two calibration steps.
• Remove the weights on the scale platform, then press the NET/GROSS key.
• Starting at the left and proceeding right, a series of dashes will appear on the display.
The dashes will stay on the display momentarily, then disappear, after which the display
will show: *-6.
Single-Point for Span Only (Last Zero) Calibration
!> – First Calibration Weight
The display will show !>. This is the first of two calibration steps. This weight is
the TEST WEIGHTS / TEST LOAD.
• Zero the scale, then place the weights on the scale platform.
• Using the numeric keys, input the value of the calibrated test weights / test load, then
press the ENTER key. NOTE! When entering values for !>, the digits start
displaying on the right side of the display and proceed to the left. When large values
are used (more than 3 digits), the !> prompt will automatically scroll off the left
side of the display to show the additional digits on the right as they are entered.
• Starting at the left and proceeding right, a series of dashes will appear on the display.
The dashes will stay on the display momentarily, then disappear, after which the
display will show: !>.
!> - Second Calibration Weight
The display will show !>. This is the second of two calibration steps.
• Remove the weights on the scale platform, and then press the ZERO key.
• The display will advance to *-6.