Specifications

8200-M411-O1 Rev D y 210/215 Installation & Technical 29
SETUP AND CALIBRATION, CONT.
Dual-Point with Zero (First Zero) Calibration
!> – First Calibration Weight
The display will show !>. This is the first of two calibration weights. This weight
could be ZERO (NO LOAD) or the TEST WEIGHTS / TEST LOAD.
• If the first calibration weight is to be ZERO (NO LOAD), press the ENTER key.
• If the first calibration weight is to be the TEST WEIGHTS / TEST LOAD, use the
numeric keys to input the value of the calibrated test weights. NOTE! When entering
values for !>, the digits start displaying on the right side of the display and
proceed to the left. When large values are used (more than 3 digits), the !>
prompt will automatically scroll off the left side of the display to show the additional
digits on the right as they are entered.
• Place the weights on the scale platform, then press the ENTER key.
• Starting at the left and proceeding right, a series of dashes will appear on the display.
The dashes will stay on the display momentarily, then disappear, after which the display
will show: !>.
!> - Second Calibration Weight
The display will show !>. This is the second of two calibration weights. This
weight could be ZERO (NO LOAD) or the TEST WEIGHTS / TEST LOAD.
• If the second calibration weight is to be ZERO (NO LOAD), press the ENTER key.
• If the second calibration weight is to be the TEST WEIGHTS / TEST LOAD, use the
numeric keys to input the value of the calibrated test weights. NOTE! When entering
values for !>, the digits start displaying on the right side of the display and
proceed to the left. When large values are used (more than 3 digits), the !>
prompt will automatically scroll off the left side of the display to show the additional
digits on the right as they are entered.
• Place the weights on the scale platform, then press the ENTER key.
• Starting at the left and proceeding right, a series of dashes will appear on the display.
The dashes will stay on the display momentarily, then disappear, after which the display
will show: !>.
!> - Last Calibration Weight
The display will show !>. This weight is not used. Press the ENTER key to skip
!> and advance to *-6.