Specifications

8200-M411-O1 Rev D y 210/215 Installation & Technical 23
SETUP AND CALIBRATION, CONT.
$> (Capacity)
Press the ENTER key to show the current value. If the setting displayed is acceptable, press
the ENTER key again to save it. Otherwise, using the numeric keys enter the new setting,
then press the ENTER key to save it. Allowable values are: 1 through 999,999.
NOTE! Capacity cannot exceed 999,999.
'0-;> (Weighing Unit 2)
Press the ENTER key to show the current value. If the setting displayed is acceptable, press
the ENTER key again to save it. Otherwise, using the numeric keys enter the new setting,
then press the ENTER key to save it. Allowable values are:
0 = none 4 = oz (ounces)
1= tn (tons) – Only on 210 5 = kg (kilograms)
2= g (grams) 6 = tonnes (metric tons) – Only on 210
3 = lb (pounds) 7 = lb/oz (pounds/ounces)
NOTE! The selection for '0-; cannot be the same as '0-;. In addition,
dependent upon the selection for '0-; and the interval and decimal point settings,
not all unit combinations are available.
;9> (Zero Tracking Range)
Press the ENTER key to show the current value. If the setting displayed is acceptable, press
the ENTER key again to save it. Otherwise, using the numeric keys enter the new setting,
then press the ENTER key to save it. Allowable values are: 0 (disables Zero Tracking), .5, or 1
through 9.
;9!> (4% Zero Range)
Press the ENTER key to show the current value. If the setting displayed is acceptable, press
the ENTER key again to save it. Otherwise, using the numeric keys, 0/NO or 1/YES, enter the
new setting, then press the ENTER key to save it.
;9!> (Yes) ;9!> (No)
4% of scale capacity Full capacity (no limit)
$'#> (Power-Up Zero Feature)
Press the ENTER key to show the current value. If the setting displayed is acceptable, press
the ENTER key again to save it. Otherwise, using the numeric keys, 0/NO or 1/YES, enter the
new setting, then press the ENTER key to save it.
$'#> (Yes) $'#> (No)
Automatic Re-Zero on Power-Up No Re-Zero on Power-Up
;3`> (12 or 24 Time Format)
Press the ENTER key to show the current value. If the setting displayed is acceptable, press
the ENTER key again to save it. Otherwise, use the numeric keys to select the format (12 or
24 hour) of the Model 210 clock operation, then press the ENTER key to save it. Note that in
the 24 hour format, 12 is added to all times after noon, i.e. 3 PM would be 1500.
;3`> 12 ;3`> 24
12 hour clock (3PM displays 3:00) 24 hour clock (3PM displays 15:00)