Specifications

8200-M242-O1 y 210-FE
Page 33
SETUP AND CALIBRATION, Cont
+.7 (+.7) - Serial Input/Output
With +.7 (+.7) displayed, press the ENTER key. The display will change to show the
current setting “1$”. To skip configuring the +.7 (serial input/output) and proceed to the
%:.1< menu, press the ENTER key again. To configure the +.7, press the numeric key
1/YES and then the ENTER key. The display will change to 3=4?.
3(4? (Serial Port Baud Rate)
Press the ENTER key to show the current value. If the setting displayed is acceptable, press
the ENTER key again to save it. Otherwise, use the numeric keys to enter a new baud rate for
the serial ports and then press the ENTER key to save it. Allowable values are:
12 = 1200 Baud 24 = 2400 Baud 48 = 4800 Baud
96 = 9600 Baud 19 = 19.2k Baud 38 = 38.4k Baud
76 = 76.8k Baud
%:<>? (Serial Port Parity)
Press the ENTER key to show the current value. If the setting displayed is acceptable, press
the ENTER key again to save it. Otherwise, using the numeric keys enter the new setting and
then press the ENTER key to save it. Allowable values are: 0, 1, or 2.
0 = NONE (No Parity) 1 = Odd Parity 2 = Even Parity
3.<+? (Serial Port Data Bits)
Press the ENTER key to show the current value. If the setting displayed is acceptable, press
the ENTER key again to save it. Otherwise, using the numeric keys enter the new setting and
then press the ENTER key to save it. Allowable values are: 7 or 8.
+<7%? (Serial Port Stop Bits)
Press the ENTER key to show the current value. If the setting displayed is acceptable, press
the ENTER key again to save it. Otherwise, using the numeric keys enter the new setting and
then press the ENTER key to save it. Allowable values are: 1 or 2.
71<? (Continuous Output Serial Port 1)
Press the ENTER key to show the current value. If the setting displayed is acceptable, press
the ENTER key again to save it. Otherwise, using the numeric keys, 0/NO or 1/YES, enter the
new setting and then press the ENTER key to save it.
71<? (Yes) 71<? (No)
Continuous Output No Continuous Output
If you selected 71<? (Yes Continuous Output), an additional prompt, <>%? will be
displayed.
If you selected 71<? (No Continuous Output) proceed to the Weight On Demand
section.
<>%? (Continuous Output Format)
Press the ENTER key to show the current value. If the setting displayed is acceptable, press
the ENTER key again to save it. Otherwise, using the numeric keys enter the new setting and
then press the ENTER key to save it. Allowable values are:
0 = SMA 1 = SB-400 2 = SB-200 3 = Rice Lake IQ355
4 = AnDFV 5 = WI110 6 = Number 7 = Toledo Short