Specifications

8200-M242-O1 y 210-FE
Page 25
SETUP AND CALIBRATION, Cont.
<:"? (4% Zero Range)
Press the ENTER key to show the current value. If the setting displayed is acceptable, press
the ENTER key again to save it. Otherwise, using the numeric keys, 0/NO or 1/YES, enter the
new setting and then press the ENTER key to save it.
<:"? (Yes) <:"? (No)
4% of scale capacity Full capacity (no limit)
%($? (Power-Up Zero Feature)
Press the ENTER key to show the current value. If the setting displayed is acceptable, press
the ENTER key again to save it. Otherwise, using the numeric keys, 0/NO or 1/YES, enter the
new setting and then press the ENTER key to save it.
%($? (Yes) %($? (No)
Automatic Re-Zero on Power-Up No Re-Zero on Power-Up
<4? (12 or 24 Time Format)
Press the ENTER key to show the current value. If the setting displayed is acceptable, press
the ENTER key again to save it. Otherwise, use the numeric keys to select the format (12 or
24 hour) clock operation and then press the ENTER key to save it. Note that in the 24 hour
format, 12 is added to all times after noon, i.e. 3 PM would be 1500.
<4?a <4?a
12 hour clock (3PM displays 3:00) 24 hour clock (3PM displays 15:00)
a7(<? X, Y (Digital Output)
Press the ENTER key to show the current value. If the setting displayed is acceptable, press
the ENTER key again to save it. Otherwise, use the numeric keys to select the X, Y values for
the digital output and then press the ENTER key to save it.
4a7=<? X, Y
where: X = State below cutoff (0 = LOW, 1 = High)
Y = Preset Number or Checkweigher Mode
0 =
Digital Output is disabled
1 =
Low State before cutoff with 1 active Preset
2 =
Low State before cutoff with 2 active Presets
3 =
Low State before cutoff with 3 active Presets
11 =
High state before cutoff with 1 active Preset
12 =
High state before cutoff with 2 active Presets
13 =
High state before cutoff with 3 active Presets
4 =
Low State before cutoff on Checkweigher Mode
14 =
High state before cutoff on Checkweigher Mode
5 =
Axle Weigher Operation Mode