Specifications

8200-M242-O1 y 210-FE
Page 22
SETUP AND CALIBRATION, Cont.
DO NOT operate the keypad with pointed objects (pencils, pens, etc).
Damage to keypad resulting from this practice is NOT covered under warranty.
During the setup and calibration process it is necessary to enter operational parameters via the
indicator’s keypad. Pressing the ENTER key without
entering a new value will retain the
current setting and advance to the next prompt. To change a setting, enter a new value and
press the ENTER key. This will save the new value and advance to the next prompt. Pressing
the 4 (ASTERISK) key will "backup" to the previous prompt.
If you press the ENTER key at the +5<(% prompt, you may proceed through to the next
section (up to and including +%1) by pressing the ENTER key.
NOTE! Setup may be interrupted at any time. ALL data previously entered
and finalized with the ENTER key will be retained in the non-volatile memory.
Pressing the calibration switch at any prompt will return you to the SEtUP menu. To exit setup,
press the 4 key with any of the above menu selections displayed or cycle power at any time
(press the ON/OFF key twice).
+<(%a
(+? (Domestic or International)
With +<(% displayed, press the ENTER key. The display will change to (+?. Press the
ENTER key to show the current value. If the setting displayed is acceptable, press the ENTER
key again to save it. Otherwise, using the numeric keys, 0/NO or 1/YES, enter the new setting
and then press the ENTER key to save it.
(+? (Domestic) (+? (International)
2<5? mm/dd/yy 2<5? dd/mm/yy
':0?a17a ':0?a>5;a
29 + 4% to OC 29 + 9 grads to OC
PT printed with tare
Lamp test on power up
If you selected (+a?a (International), an additional prompt, %++? will be displayed.
If you selected (+a?a (Domestic) proceed to "<? (Legal For Trade).
NOTE! With the exception of the +<(% prompt, the prompts displayed for each section
are different if you push the calibration switch instead of pressing the ENTER key to
proceed through the section. For example, if you press the calibration switch with the
+<(% displayed, the next prompt displayed will be A4. If you step through the setup
prompts by pressing the ENTER key, the next prompt displayed will be A4. In addition,
at a prompt with the question mark () displayed, you must press the ENTER key, the
1/YES key and then the ENTER key again to proceed with that section. To skip the
section and advance to the next menu selection, press the ENTER key twice.