Specifications

8200-M242-O1 y 210-FE
Page 18
KEYPAD FUNCTIONS, Cont.
4 and NET/GROSS KEY, NET/GROSS KEY, ZERO KEY
This combination will zero (clear) the Gross accumulator.
4 and UNITS KEY
This combination will enter the Test mode. The Test mode is used to test of all the
display elements. It consists of five (5) cycles, each lasting about one (1) second:
1. All horizontal segments will turn on.
2. All vertical segments and decimal points will turn on.
3. All annunciator display segments will turn on.
4. All display elements off.
5. The model number (210-FE) and the software version X.X.
6. The calibration numbers (C1 to C4).
4 and PRINT KEY
This combination is used to change the selected print ticket format. Pressing the 4
and then the PRINT key will display a prompt %:<?. Press the ENTER key to show
the current value. If the setting displayed is acceptable, press the ENTER key again
to save it. Otherwise, using the numeric keys enter the new setting and then press
the ENTER key to save it. Allowable values are:
0 = print tab settings 1 = visual ticket format 1 2 = visual ticket format 2
In addition to using the 4 and PRINT key combination to change the print ticket
format, the operator (just prior to printing the ticket) can change the print ticket format
at the end of the weighing operation. This is accomplished by performing the normal
weighing operation and then pressing the desired format number (0, 1 or 2), followed
by pressing the PRINT key.
NOTE! When a print format is selected (by either method), it will
remain active until changed by the operator.
DISPLAY BRIGHTNESS
The 210-FE indicator has an extra-bright 2 1/2” LED weight display. Ten levels of brightness
can be set from the 210-FE keypad by using a combination of the 4 key and the 1 or 0 key.
To Increase Brightness:
1. Press the 4 key and then the 1 key.
2. Repeat pressing the 1 key to increase the brightness to the desired level.
3. When the brightness is at the desired level, press the ENTER key to save the setting
and return to normal operating mode.
To Reduce Brightness:
1. Press the 4 key and then the 0 key.
2. Repeat pressing the 0 key until the brightness has been reduced to the desired
level.
3. When the brightness is at the desired level, press the ENTER key to save the setting
and return to normal operating mode.