Specifications

8200-M242-O1 y 210-FE
Page 17
KEYPAD FUNCTIONS, Cont.
NET/GROSS KEY
This key is used to toggle between the Net and Gross weight modes. The selected mode is
indicated by turning on 1 or * on the annunciator display. Note that if no valid tare weight has
been entered, pressing this key will cause a momentary 17<: display error and the
indicator will remain in the Gross weight mode.
TARE KEY (with weight "T"symbol)
Pressing this key will display the current tare weight for three seconds.
UNITS/TEST KEY
This key performs two functions. In normal operation, it is used to select the units in which the
weight is to be displayed. The available units of measure ("unit1" and "unit2") are enabled or
disabled in setup. The available units include tons, pounds, ounces, tonnes (metric tons),
kilograms, and grams. Note that not all combinations are supported. Pressing this key after
the 4 key will enter the Test mode. The Test mode is used to conduct a test of all display
elements. Refer to description of 4 key for details.
0 THROUGH 9 KEYS
These keys are used to enter numeric data during the setup and calibration as well as during
normal operation of the instrument. NOTE! The 1 and 0 keys have dual functions. They are
used to enter numeric data during setup and calibration as well as during normal operations
and are also used to answer yes (1 = YES) or no (0 = NO) to various prompts.
ENTER KEY
This key serves two purposes. First, when reviewing setup parameters, pressing the ENTER
key will display the current setting of the parameter. Second, the ENTER key is used to signal
completion of the entry of data and causes the indicator to process the data entered.
4 (ASTERISK) KEY
This key is used for several functions. During Setup, when a setup parameter (not a
parameter value) is displayed, pressing it key will "backup" to the previous prompt. In normal
operation, this key is used in conjunction with other keys on the keypad to access additional
indicator features. These features and their associated key combinations are as follows:
4 and 1/0 KEY
This combination is used to adjust the brightness of the weight display. Refer to
Display Brightness section of this manual for details.
4 and ZERO/REVIEW KEY
This combination will enter the Review mode of Setup and Calibration. Refer to
Setup Review section of this manual for details.
4 and NET/GROSS KEY
This combination will display the Net accumulator.
4 and NET/GROSS KEY, PRINT KEY
This combination will print the Net accumulator.
4 and NET/GROSS KEY, ZERO KEY
This combination will zero (clear) the Net accumulator.
4 and NET/GROSS KEY, NET/GROSS KEY
This combination will display the Gross accumulator.
4 and NET/GROSS KEY, NET/GROSS KEY, PRINT KEY
This combination will print the Gross accumulator.