Specifications

8200-M242-O1 y 210-FE
Page 6
INSTALLATION
Before beginning installation of your 210-FE Weight Indicating Instrument, make certain that
the instrument has been received in good condition. Carefully remove the instrument from the
shipping carton and inspect it for any evidence of damage (such as exterior dents or
scratches) that may have taken place during shipment. Keep the carton and packing material
for return shipment if it should become necessary. It is the responsibility of the purchaser to
file all claims for any damages or loss incurred during transit.
Mounting
The Model 210-FE indicator is housed in a NEMA 4X/IP66 stainless steel wall or desk-mount
enclosure. The gimbal may be mounted on a desktop or other smooth, flat, horizontal surface
or may be mounted on a wall. Refer to Figure No. 1 for a layout of wall-mounting bolts.
If wall mounted, make certain the mounting surface is strong enough to support the indicator.
The mounting location should be where the display is easily viewed while being close enough
to provide the operator easy access to the keypad. Carefully lay out the mounting hole
locations, then drill and install the anchor bolts. Attach the gimbal to the wall and securely
tighten the retaining bolts.
Figure No. 1
Figure No. 2
10.00"
Clearance for
#10 size screw
90 to 264 VAC
(50/60 Hz) @
0.4A
Load Cells
Calibration
Switch
Access
Screw