Specifications

8200-M024-O1 Rev H y 205 Installation & Technical
23
SETUP AND CALIBRATION, CONT.
Dual-Point with Zero (First Zero) Calibration
IMPORTANT! The functions of numeric keys are replaced by using the
UNITS/
LEFT ARROW and the ASTERISK/UP ARROW keys. The cursor location is
identified by the blinking character and can be advanced to the left to the next
position by pressing the UNITS/
LEFT ARROW key. Pressing the ASTERISK/UP
ARROW
key will change the blinking character to the next value.
!> – First Calibration Weight
The display will show !>. This is the first of two calibration weights. This weight
could be ZERO (NO LOAD) or the TEST WEIGHTS / TEST LOAD.
• If the first calibration weight is to be ZERO (NO LOAD), press the TARE/
ENTER key.
• If the first calibration weight is to be the TEST WEIGHTS / TEST LOAD, use the
UNITS/
LEFT ARROW and ASTERISK/UP ARROW keys to input the value of the calibrated
test weights. NOTE! When entering values for !>, the digits start displaying on
the right side of the display and proceed to the left. When large values are used (more
than 3 digits), the !> prompt will automatically scroll off the left side of the display
to show the additional digits on the right as they are entered.
• Place the weights on the scale platform, then press the TARE/
ENTER key.
• Starting at the left and proceeding right, a series of dashes will appear on the display.
The dashes will stay on the display momentarily, then disappear, after which the display
will show: !>.
!> - Second Calibration Weight
The display will show !>. This is the second of two calibration weights. This
weight could be ZERO (NO LOAD) or the TEST WEIGHTS / TEST LOAD.
• If the second calibration weight is to be ZERO (NO LOAD), press the TARE/
ENTER key.
• If the second calibration weight is to be the TEST WEIGHTS / TEST LOAD, use the
UNITS/
LEFT ARROW and ASTERISK/UP ARROW keys to input the value of the calibrated
test weights. NOTE! When entering values for !>, the digits start displaying on
the right side of the display and proceed to the left. When large values are used (more
than 3 digits), the !> prompt will automatically scroll off the left side of the display
to show the additional digits on the right as they are entered.
• Place the weights on the scale platform, then press the TARE/
ENTER key.
• Starting at the left and proceeding right, a series of dashes will appear on the display.
The dashes will stay on the display momentarily, then disappear, after which the display
will show: !>.
!> - Last Calibration Weight
The display will show !>. This weight is not used. Press the TARE/
ENTER key to
skip !> and advance to *-6.