Specifications

8200-M024-O1 Rev H y 205 Installation & Technical
17
SETUP AND CALIBRATION, CONT.
Pressing the calibration switch at any prompt will return you to the *;'$ menu. To exit
setup, press the ASTERISK/
UP ARROW key with any of the above menu selections displayed
or cycle power at any time (press the ON/OFF key twice).
*``;`'`$`
'*> (Domestic or International)
With *;'$ displayed, press the TARE/
ENTER key. The display will change to '*>. Press
the TARE/
ENTER key to show the current value. If the setting displayed is acceptable, press
the TARE/
ENTER‘ key again to save it. Otherwise, use the ASTERISK/UP ARROW key to toggle
to a new setting and then press the TARE/
ENTER key to save it.
'*> (Domestic) '*> (International)
;9!`> no ;9!`> yes
$ + 4% to OC $ + 9 grads to OC
PT printed with tare
Lamp test on power up
!;> (Legal For Trade)
Press the TARE/
ENTER key to show the current value. If the setting displayed is acceptable,
press the TARE/
ENTER‘ key again to save it. Otherwise, use the ASTERISK/UP ARROW key to
toggle to a new setting and then press the TARE/
ENTER key to save it.
!;>` !;>`
Interval Settings ()0;>) allowed
are: 1, 2, 5, 10, 20, 50
Interval Setting ()0;>) is
selectable from 1 to 99.
NOTE! When both !;> and '*>, the followings results occur:
Scale must have between 100 and 10,000 divisions
;9`> .5 or 0 to 3
Inhibit serial data during input
;9!`> no
$ + 4% to OC
NOTE! When !;> and '*>, the followings results occur:
'0*`> 1
;9!`> yes
$ + 9 grads to OC
PT printed with tare
Lamp test on power up
NOTE! With the exception of the *;'$ prompt, the prompts displayed for each section
are different if you push the calibration switch instead of pressing the TARE/
ENTER key to
proceed through the section. For example, if you press the calibration switch with the
*;'$ displayed, the next prompt displayed will be @3. If you step through the setup
prompts by pressing the TARE/
ENTER key, the next prompt displayed will be @3. In
addition, at a prompt with the  displayed, you must press the TARE/
ENTER key, the
1/YES key then the TARE/
ENTER key again to proceed with that section. To skip the
section and advance you to the next menu selection, press the TARE/
ENTER key twice.