Specifications

8200-M024-O1 Rev H y 205 Installation & Technical
12
KEYPAD FUNCTIONS
The Model 205 is equipped with a 7-key keypad. The keypad is used to enter commands and
data into the indicator. This section describes each key along with its normal function. It is
helpful to refer to the actual indicator while reading this section.
Figure No. 8
DO NOT operate the keypad with pointed objects (pencils, pens, etc).
Damage to keypad resulting from this practice is NOT covered under warranty.
ON/OFF KEY
This key performs two functions. Pressing it when the indicator is off will apply power to the
indicator. If the indicator is already on, pressing this key will turn the indicator off.
ZERO KEY/
REVIEW
Pressing this key will cause an immediate zeroing of the weight display up to the selected limit
of 4% or 100% of the scale’s capacity. This selection is made during the setup and calibration
of the indicator. Note the indicator will not respond to this command unless the weight display
is stable.
Pressing the ASTERISK key before the ZERO KEY/
REVIEW key will enter the Review
mode of Setup and Calibration. Refer to the Setup Review section of this manual.
TARE/
ENTER
Pressing the TARE key alone will store the current gross weight as the new tare weight and
the weight display will change to the net weight display mode (
Net annunciator will turn on).
Pressing the ASTERISK key before the TARE/
ENTER key serves two purposes. First,
when reviewing setup parameters, pressing the TARE/
ENTER key will display the
current setting of the parameter. Second, the TARE/
ENTER key is used to signal
completion of the entry of data and causes the indicator to process the data entered.