Specifications

INSTALLATION, CONT.

Battery Door

Serial I/O

Thumb

Screw

Ground Lu

Load Cell

12 VDC

Figure No. 2

Batteries

The 204 indicator can use 6 "C" size Alkaline, Ni-Cad or NiMH batteries (not included). You

must first obtain and install batteries in the 204 before operations can begin. The batteries are

contained in a battery holder inside the indicator. Access is via a removable panel on the back

of the indicator.

The 204 can operate for 200 hours of continuous use when using Alkaline batteries or with

fully charged Ni-Cad or NiMH batteries, 50 hours of continuous use.

IMPORTANT! The 204 indicator can be operated from Alkaline, Ni-Cad or NiMH

batteries or from an AC power adapter. All six (6) batteries must be of the same

type. They must all be Alkaline, all Ni-Cad or all NiMH. DO NOT mix Alkaline and

Ni-Cad or NiMH batt

eries.

IMPORTANT! The AC power adapter is also used to recharge the batteries, when

the 204 is operated from Ni-Cad or NiMH batteries. DO NOT connect the AC power

adapter to the 204 if using Alkaline batteries. Also, when using Alkaline batteries,

make sure the

niCAd

setup option is disabled (set to 0). Refer to Setup and

Calibration or Setup Review.

CAUTION: RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN INCORRECT

TYPE. DISPOSE OF USED BATTERIES ACCORDING TO THE INSTRUCTIONS.

ATTENTION: RISQUE D'EXPLOSION SI LA BATTERIES EST REMPLACE'E PAR UN

TYPE INCORRECT. REJETEZ LES BATTERIES UTILISE'ES SELON LES

INSTRUCTIONS.

8555-M313-O1 Rev G x 204 Installation & Technical