Specifications

INSTALLATION, CONT.

Battery Installation/Replacement

To install or remove the batteries, the following steps should be followed:

1. Make sure the AC power adapter is unplugged.

2. Remove the indicator from the mounting bracket and turn the indicator over so that the

display is facing away from you.

3. Locate the rectangular panel on the back of indicator and remove the thumb screw.

4. Remove the panel (lift straight up and slide it out) exposing the battery holder.

5. If installing new batteries, proceed to step 6. If replacing the batteries, remove all 6

batteries from the battery holder and then proceed to step 6.

6. Install the new 6 "C" size batteries in the holder, noting the polarity markings located in

the battery holder. Refer to Figure No. 3.

7. After placing all 6 batteries in holder, replace panel on back of indicator (slide tab into

slot on rear panel) and install thumb screw.

8. Turn the indicator over (display facing up) and press the ON|OFF key.

9. If display turns on, batteries have been installed correctly. If not, remove panel and

check for one or more improperly positioned batteries.

10. Return the indicator to the mounting bracket.

11. The indicator is now ready for operation.

Figure No. 3

Low Battery Indicator

When the batteries are near the point they need to be replaced (Alkaline) or recharged (NiCad

or NiMH), the low battery annunciator on the display will turn on (see Figure No. 7). If the

battery voltage drops too low for accurate weighing, the indicator will automatically shut off and

you will be unable to turn it back on.

Using Alkaline Batteries

When the low battery annunciator turns on, turn the indicator off, remove the old batteries

and replace with new ones.

Using NiCad or NiMH Batteries

When the low battery annunciator turns on (and the

niCAd

setup option is enabled, set to 1

or 2), plug the AC power adapter into the indicator and then into the proper electrical wall

outlet. The indicator will begin charging the batteries.

8555-M313-O1 Rev G x 204 Installation & Technical