User`s guide

- 6 -
This chart explains the five normal ways to arm the system from a Standard keypad. (For a Master keypad see page 37.)
The green Status Light must be on steady and the display* must read “Ready to Arm” in order to arm the system with one of
these commands. If the green Status Light is not on, or if the display* is reading “Not Ready,”
see Force Arming or Zone Bypass for other ways to arm the system.
Note: In commercial burglar alarm applications for U.L. Listed systems, a ring-back indication and bell
test should be heard after arming (closing). If not heard, call for service.
Turning ON (arming) your System
continued on next page
* = DS7447/DS7447E only
** = DS7445/DS7445i only
Type of Arming Desired
Command
Sequence
What will Happen
What to Do
Normal Arming
No one left on the
premises.
An entry/exit delay
is in effect.
[PIN] + [On]
The red Armed Light will begin to flash.
“Armed” will be displayed.*
“Exit Now” will be displayed during the exit delay
interval.*
A single beep will sound.
The red
Armed Light will turn on steady after the exit
delay expires.
Exit during the exit
delay interval.
Perimeter Arming
Someone still on the
premises.
There is NO entry delay
in effect.
[PIN] +
[No Entry] +
[Perimeter Only]
The red Armed Light will begin to flash.
“Perimeter Inst.” will be displayed.*
“Exit Now” will be displayed during the exit delay
interval.*
The green
Status Light will turn on steady.
A single beep will sound.
Only exterior protection zones will be armed.
The red
Armed Light will turn on steady after the exit
delay expires.
The yellow
Perimeter Light will turn on steady.**
Move freely around
the interior.