User`s guide

- 5 -
Volume Control: The keypad sounder volume can be adjusted using the [1] and [4] keys along with the [*] key.
- Hold the [*] key while pressing the [1] key to increase the volume or the [4] key to decrease the volume.
Backlight Control (DS7447/DS7447E Only): The display backlight intensity can be adjusted using the [3] and [6] keys along with
the [*] key.
- Hold the [*] key while pressing the [3] key to increase the brightness or the [6] key to decrease the brightness.
Note: After the backlight and volume are adjusted you must arm and disarm the system once to store this information in the
control panel. If power is disconnected before the panel is armed, the backlight and volume levels will return to the
default settings.
Understanding the DS7447/DS7447E and DS7445/DS7445i Keypads (continued)
These Lights Present on the DS7445/DS7445E Only:
Light Off Flashing On
Perimeter
(yellow)
Supervisory
(yellow)
Bell
Silenced
(red)
Trouble
(yellow)
Panel is disarmed or
is not armed Perimeter.
There are no supervisory
alarms present.
The bells do not need to be
or have not been silenced.
There are no trouble
conditions.
This Light will not flash.
A supervisory condition exists.
This Light will not flash.
This Light will not flash.
The perimeter is armed.
This Light will not turn on steady.
There has been a Fire alarm and the bells
have been silenced. To clear, enter the
Fire Reset command: [PIN] + [System Reset
].
A trouble condition exists.
LEDs 1-8
(red)
There are no zone alarms.
A zone (1-8) has been
alarmed.
A zone (1-8) is Not Ready to Arm, or
if a fire zone, a trouble condition exists.