User`s guide

- 34 -
This chart explains the procedure for performing a Communicator Test.
This test is available only if your system transmits alarms and system information to a monitoring service, and has been
programmed by the security installing company to permit communicator tests.
This test can be performed from a Master Keypad. The account code for partition #1 will be used.
A long beep will initially sound to acknowledge the start of the test.
If the test is successful, the sounder will again issue one long beep.
If the test fails, the keypad sounder will turn ON continuously.
To silence the sounder, enter your [PIN] followed by the [#] key or press the [*] key.
Testing your System (continued)
What will Happen
Command
Sequence
[PIN] + [#] [8] [2]
Type of
Test
Communicator
Test
What to Do
If test fails, the keypad sounder will sound continuously.
To silence the sounder, press the [System Reset] key.
Note: This test may take several minutes to complete
because the control will try 10 attempts before it fails
this test.
A long beep will sound.
A “Test” report is sent to
the monitoring service.