Specifications

tant high current through the base-to-emitter of
Q7802 and R7811 (15 ohms) to ground would cause
both Q7803 and R7811 to fail.
Page 8, paragraph 9a: First sentence, delete
*’R7902° and replace it with R7802.
Page 9, paragraph 10c: Third sentence, line 8;
delete “base” and replace it with collector.
Page 9, paragraph 10d: In line two, delete
"DS7902 and DS7901" and replace it with DS7901
and DS7902.
Page 11, paragraph 12b: In line 4; change
“R7817" to R7921 .
Page 11, paragraph 12c: In line 2, change “ +22
volts dc” to between 21.0 and 22.0 volts dc.
Page 11, paragraph 12d: At the end of paragraph
12d, place the following:
Note
In the AN/VRM-1A models that contain
TS-1777A/VRC with serial numbers 802
and higher, inductor L7302 has been re-
placed with resistor R7304.
Page 12, paragraph 14. Add the following
sentence after the second sentence:
In some equipment (para 1d(5)(d)), the test voltage
is connected through rf choke L7301 and across
voltage divider network consisting of variable
resistor R7902 and resistors R7923 and R7917 (fig.
9.1).
Paragraph 15, line 5. “C7503” is changed to
read C7501.
Page 13. Figure 9 is superseded by a new figure 9.
2