Specifications
APPENDIX II
GENERAL SUPPORT AND DEPOT MAINTENANCE REPAIR
PARTS AND SPECIAL TOOLS LIST
Section I.
INTRODUCTION
1. Scope
at indicated maintenance categories.
This appendix lists repair parts required for
M—Repair parts which are not procured or
the performance of general support and depot
stocked, but are to be manufactured at
maintenance of the AN/VRM-1 and AN/VRM-
indicated maintenance levels.
1A
2.
NOTE
No special tools, test, or
ment is required.
General
A—Assemblies which are not procured or
support equip-
stocked as such, but are made up of two
or more units. Such component units
carry individual stock numbers and de-
scriptions, are procured and stocked
This repair parts list is divided into the follow-.
separately and ‘can be assembled to
ing sections:
a. Repair Parts-Section II. A list of repair
parts authorized for the performance of main-
tenance at the general support and depot level.
b. Index—Federal Stock Number and Refer-
ence Number Cross-Reference to Figure and
Item Number or Reference Designation-Sec-
tion III. A list of Federal stock numbers in as-
cending numerical sequence, followed by a list
of reference numbers in ascending alphanu-
merit sequence, cross-referenced to the figure
number and reference designation.
c. Index-Reference Designation Cross-Ref-
erence to Page Number-Section IV. A list of
reference designations cross-referenced to page
numbers.
3. Explanation of Columns
The following provides an explanation of col-
umns in the tabular lists:
a. Source, Maintenance, and Recoverability
Codes (SMR), Column 1.
(1) Source codes indicate the selection
status and source for the listed item. Source
codes are-
Code
Explanation
P—Repair parts which are stocked in or sup-
plied from the GSA/DSA, or Army
supply system, and authorized for use
form the required assembly at indicated
maintenance categories.
X1—Repair parts which are not procured or
stocked. The requirement for such items
will be filled by use of the next higher
assembly or component.
X2—Repair parts which are not stocked. The
indicated maintenance category requir-
ing such repair parts will attempt to
obtain same through cannibalization.
Where such repair parts are not obtain-
able through cannibalization, require-
ments will be requisitioned, with ac-
companying justification, through nor-
mal supply channels.
(2) Maintenance codes indicate the lowest
category of maintenance authorized to install
the listed item. The maintenance level codes
are-
Code
Explanation
0 . ----- - Organizational maintenance
H - - - - - - General support maintenance
D------
Depot maintenance
(3) Recoverability codes indicate whether
unserviceable items should be returned for re-
covery or salvage. Items not coded are expend-
able. Recoverability codes are-
I