Specifications

Figure 15. Test Set, Radio TS-1777/VRM-1 front panel chassis, top view.
x. Replacement of Resistors Mounted on
switch
(1)
(2)
S7902.
Cut the resistor leads to the proper
length and make a good mechanical
connection at the solder lugs of
switch S7902.
solder the resistor 1 e a d to the
39.
solder lugs of switch S7902. Be
careful not to damage or drop
solder into the contacts of switch
S7902.
Removal and Replacement of Case
Gasket
(fig. 18)
a. Removal. Remove the gasket by peel-
ing it off the case face.
b. Replacement.
Apply sealant to the
replacement gasket and apply it to the
case face so that the holes in the gasket
line up with the holes in the case.
40. Repair of Cables
a. Removal of Test Probe Cable (fig. 15
and 19).
(1)
(2)
(3)
(4)
Remove the outer cable shield con-
nection from terminal E7903.
Remove the inner cab1e shield
connection at the ground lug on
connectcr J7904.
Remove the inner cable conductor
connection at terminal E7912.
Remove the coupling nut on the
front panel front side of the probe
cable box connector, and remove
the cable, nut, washer, and grom-
met.
29