User guide

DS7060 User Guide Copyright © 1996-97 Detection Systems, Inc. Page 15
1.10 Chime Mode
Chime Mode causes the keypad sounders to beep each time a Perimeter or Entry/Exit zone is violated while the control panel is off (disarmed).
The [#] [7] command is used to both turn Chime Mode off and on.
This chart explains the procedure for turning ON and turning OFF Chime Mode.
* If in “Residential Mode” substitute the [#] key for the PIN.
1.11 Zone Test
The Zone Test is used to confirm that detectors will report alarms. Zone Test works on all zones, except 24-hour zones and fire zones. While the
keypad is in Zone Test, no control panel alarms will activate an alarm, except 24-hour zone alarms and fire alarms. These will override the Zone
Test function.
Caution: Be sure not to activate 24 hour or fire zones during the zone test or an alarm signal will be sent.
The Zone Test will initiate communicator reports only if both “System in Test Report” and “System in Test Restoral Report” are programmed. Ask
your installation company if you desire this feature.
Page 18
1.13 Communicator Test
This test is only available if your system transmits alarms and system information to a monitoring service, and has been programmed by the
security installing company to permit communicator tests. This test may only be used in the disarm mode.
A long beep will initially sound to acknowledge the start of the test. If the test is successful, the sounder will again issue one long beep. If the test
fails, the keypad sounder will beep three times and the Power LED will begin to flash, indicating a Control Trouble. The DS7447
keypad will display “Control Trouble Enter #87. When performing the #87 error display sequence, the DS7447 keypad will display “Control Trouble
Communication Err”. The DS7443 and DS7445 keypads will turn on the Zone 3 LED. See Section 1.17.