User guide

Page 14

This chart explains the procedure for bypassing a faulted zone prior to arming the system.

* If in “Residential Mode” substitute the [#] key for the PIN.

NOTE: All bypasses are cleared when the system is disarmed, unless they are on 24-hour zones. To clear a bypass on a 24-hour zone, use

Clear Individual or Clear All.

1.14 Read Alarm History

This feature will display which zones were in alarm during the last armed period. The alarm memory will remain from one armed cycle to the next

if no new alarms occur. Alarm memory will clear when entering programmers mode.

To exit the Alarm History Mode, press the [*] key or wait 5 seconds and the keypad will exit automatically.

1.15 Fire Reset/Fire Trouble

Fire Reset

During a fire alarm, exit the premises immediately. When you have determined there is no fire, you may silence the bells/sirens before you can

initiate the [System Reset] command. PIN + [Off] will silence the sounders.

This will allow a determination of which smoke detector has alarmed so the monitoring company may verify its operation.

A PIN followed by the [System Reset] key will reset any smoke detectors after a fire alarm has occurred.

The System Reset command will perform a fire reset, will perform a battery test, and will clear all system troubles.