User guide

6.0 HOW TO PROGRAM THE DS7060

To enter the programming mode, the panel must be disarmed. When in the programming mode the control is disabled and no alarms will be

processed, including 24-hour zones and fire zones.

To enter the Programmer’s Mode, enter the Programmer’s Code followed by [#] [0]. The default Programmer’s Code is 9876. Enter the

Program Address, i.e. [0] [2]. Press the [#] to change the values. After all values have been changed, press the [#] to accept the changes

and return to the Program Address. Repeat the above until all addresses are programmed.

NOTE: Some data digit values are higher than 9. These values are programmed by pressing the reset [*] key followed by another number.

These values will display as HEX characters when entered. The HEX character values are:

*0 = A, *1 = B , *2 = C, *3 = D, *4 = E, *5 = F.

To exit the Programmer's Mode, press the [*] key for 2 seconds. Also, if no keypad entries are made for 4 minutes, the control will automat-

ically exit from the Programmer's Mode.

7.0 PROGRAMMING THE DS7060

Most control panel functions are controlled using a single program address. Some functions are grouped into one address. For example:

The keypad emergency keys are programmed in Address 19. The first data digit of this address is for the Fire Key, the second is for the Help

Key, and the third is for the Panic Key. Other addresses are configured this way also, with the address representing a group of functions and

each data digit controlling a specific function.

Example: To program the Fire Key as Pulsing Audible, the Help Key as Steady Audible and the Panic Key as Invisible.

Use the following chart for each Address to record your selections before programming.

Enter the Programmer's Mode: [9] [8] [7] [6] [#] [0] will display the program mode

Enter the Program Address: [1] [9]

Enter: [#] to change the values

Enter: [3] in the first data field to change the Fire Key to Pulsing Audible

Enter: [2] in the second data field to change the Help Key to Steady Audible

Enter: [1] in the third data field to change the Panic Key to Invisible

Enter the Pound button: [#]

Program the next Address, a different Address, or exit the Programmer's Mode.